SYD-255A液体石油沥青蒸馏试验器

武汉格莱莫检测设备有限公司 电话：13545068882 027-86619889

传真：027-86619889   网址：www.glmgs.com

一、产品简介
One, product introduction
本仪器是按照国家行业标准JTJ052《公路工程沥青及沥青混合料试验规程》中的T0632《液体石油沥青蒸馏试验》规定的要求设计制造的，适用于测定液体石油沥青的馏分含量。
The apparatus in accordance with the national industry standard JTJ052" highway engineering asphalt and asphalt mixture test procedures in the" T0632" liquid petroleum asphalt distillation test" in accordance with the requirements of the design and manufacture, applied in the determination of liquid petroleum asphalt fractions content.
二、技术指标
Two, technical indicators
★工作电源：交流220V±10%，50Hz。
Power supply: exchange of 220V + 10%, 50Hz.
★烧瓶罩：用铁皮制成，表面镀黑，装有木制手柄，手柄对面设有一条能使蒸馏烧瓶支管通过的缺口，烧瓶罩上开有一个长方形观察窗，窗框上插有透明的云母片。
Of cover: flask made of iron sheet, surface plating black, with wooden handle, the handle is provided with an opposite to the distillation flask branch through the notch, a flask cover is provided with a rectangular window, the window frame is inserted on the transparent mica plate.
★蒸馏烧瓶：用硬质玻璃制成，耐热500℃以上。瓶体球径为ф102±2.0mm，瓶体颈粗25±1.2mm，支管和瓶颈成75°±3°的角度。
Of the distillation flask: hard glass, heat-resistant above 500 DEG c.. The bottle body ball diameter for 102 + 2.0mm, the bottle neck is thick 25 + 1.2mm, branch and the bottleneck into 75 plus or minus 3 degree angle.
★温度计：0~360℃，分度1℃，符合国家标准GB514《石油产品试验用液体温度计技术条件》中蒸馏用温度计的规定。
Thermometer: of 0 ~ 360, dividing 1 C, in line with national standards GB514" liquid in glass thermometers for petroleum products technical conditions" in the provisions of distillation thermometer.
★冷凝管及支架：冷凝管用ф12.5±0.5的玻璃管组成，并用两个支架架起.
Of condenser tube and stent: condenser tube 12.5 + 0.5 consisting of a glass tube, and a two bracket.
★加热调温器：由加热电炉和可控硅调温电路箱壳组成，功率为1000W/220V，加热升温速率可调。
Of heating thermostat: by heating furnace and silicon controlled regulating circuit box shell, power was 1000W / 220V, heating rate adjustable.
★量筒：量筒分100毫升,分度为0.5毫升。
In a 100 ml: cylinder, dividing 0.5 ml.
★导接管：厚玻璃（约1 mm）制，牛角形，弯角约1050，大端内径18 mm，小端内径不小于5mm。
Of guide connecting tubes: thick glass (approximately 1 mm ), horn, bending angle of about 1050, outer diameter of 18 mm, the small end diameter not less than 5mm.
★电炉垫圈：用炭化硅制造，外径为ф105mm，内径分别为ф50mm、ф3mm及带缺口的三种。
Of electric washer: silicon carbide manufacturing, OD for 105mm, diameter 50mm, respectively 3mm and notched three.
★仪器工作环境温度：-10~+35℃。
Of instrument working environment temperature: - 10 ~ + 35 C.
★仪器工作相对环境湿度：≤85%。
Of instrument: less than 85% relative humidity.
★整机功耗：不大于1100W。
Power consumption: not more than 1100W.
三、基本配置
Three, the basic configuration
★加热调温器
Of heating thermostat
★蒸馏烧瓶
Of the distillation flask
★升降调节架
Lifting adjusting frame of
★烧瓶罩
Flask cover.
★冷凝管
Of condensing tube
★玻璃量筒（100毫升）
In the measuring glass ( 100 ml )
★温度计0~360℃
In 0 ~ 360 degrees Celsius thermometer
★硅胶塞（4#）
Of the silica gel plug ( 4 # )
★蒸馏瓶塞
Of distillation bottle stopper
★碳化硅垫片
Silicon carbide pad.
★温度计挡圈（1#）
Of thermometer ring (1 # )
。
.