来宝网Logo

热门词:生物显微镜 水质分析仪 微波消解 荧光定量PCR 电化学工作站 生物安全柜

AED
现在位置首页>物性测试仪器>试验机>弹性模量、阻尼分析仪>Biomomentum代理Mach-1,弯曲,三点弯曲,bending test, 3D NORMAL INDENTATION MAPPING骨弯曲
Biomomentum代理Mach-1,弯曲,三点弯曲,bending test, 3D NORMAL INDENTATION MAPPING骨弯曲
Biomomentum代理Mach-1,弯曲,三点弯曲,bending test, 3D NORMAL INDENTATION MAPPING骨弯曲
  • Biomomentum代理Mach-1,弯曲,三点弯曲,bending test, 3D NORMAL INDENTATION MAPPING骨弯曲

Biomomentum代理Mach-1,弯曲,三点弯曲,bending test, 3D NORMAL INDENTATION MAPPING骨弯曲

产品报价:询价

更新时间:2020/2/10 10:23:02

地:加拿大

牌:Biomomentum

号:Mach-1 v500c MA001

厂商性质: 生产型,贸易型,服务型,

公司名称: 世联博研(北京)科技有限公司

产品关键词: Torsion   扭转力测试   骨扭转   Mach-1   biomomentum  

719
访问人数
0
累计评论


陈宝华 : (13060393900) (13060393900)

(联系我时,请说明是在来宝网上看到的,谢谢!)


弯曲

弯曲(或弯曲)测试表征了细长样品的行为(一维只是其纵向的一小部分-其他两个十分之一),并且垂直于其纵轴施加了载荷。该测试配置在评估功能为支撑约束的结构元素(例如梁或骨头)时特别有用。在三点弯曲测试中,样品放置在对称放置的两个支撑杆上,长度约为样品长度的75%,而上杆施加垂直变形以使样品在底部杆之间的中心弯曲。在四点形式中,单个上杆由安装在中心枢轴点上的两个杆代替,两个杆对称地放置在样品长度的大约25%处。这种设置减少了在三点形式的加载点下观察到的应力集中,并将其分布在两个加载点之间的较大区域,避免了样品过早失效。4点弯曲测试对于非均质材料特别有用。两种弯曲测试均提供弯曲时的弹性模量和材料的弯曲应力-应变响应值。

BENDING

Bending (or flexure) tests characterize the behavior of a slender sample (one dimension being a small fraction - a tenth - of the other two) with load applied perpendicular to its longitudinal axis. This test configuration is particularly useful in evaluating a structural element whose function is to support constraints, e.g. beams or bones. In a 3-point bending test, the sample rests on two support rods placed symmetrically at approximately 75% of the sample's length, while an upper rod applies vertical deformation to bend the sample at the center between the bottom rods. In a 4-point version, the single upper rod is replaced by two rods, mounted on a central pivot point, placed symmetrically at approximately 25% of the sample's length. This setup reduces stress concentration observed under the loading point in the 3-point version and distributes it over a larger region between the two loading points, avoiding premature failure of the sample. 4-point bending tests are particularly useful for non-homogeneous materials. Both bending tests provide values for the modulus of elasticity in bending and the flexural stress-strain response of the material.

参考文献

Determining the modulus of intact bovine vertebral cancellous bone tissue: Development and validation of a protocol

Engbretson AC

Master thesis Queen's University. (2010)


Mach-1 - 3-point or 4-point Bending Test (MA056-SOP11-D v2)

Sim S and Quenneville E

Biomomentum Inc. Laval (QC), Canada, Effective Date: March 9th, 2016


Mach-1 Analysis - Extraction of Mechanical Parameters Following Bending Test (SW186-SOP08-D v2)

Sim S

Biomomentum Inc. Laval (QC), Canada, Effective Date: March 9th, 2016


Can the contralateral limb be used as a control during the growing period in a rodent model?

Mustafy, T., Londono, I., & Villemure, I.

Medical Engineering and Physics, 58, 31–40. https://doi.org/10.1016/j.medengphy.2018.04.013


High Impact Exercise Improves Bone Microstructure and Strength in Growing Rats

M. Tanvir, I. Londono, F. Moldovan and I. Villemure

Nature Scientific Reports, volume 9, Article number: 13128 (2019) https://doi.org/10.1038/s41598-019-49432-2


Bone-Specific Overexpression of PITX1 Induces Senile Osteoporosis in Mice Through Deficient Self-Renewal of Mesenchymal Progenitors and Wnt Pathway Inhibition

N.Karam, J-F. Lavoie, B. St-Jacques, S. Bouhanik, A. Franco, N. Ladoul and A. Moreau